1. No matter what the outputimpedance of the amplifier is!
这和放大器的输出阻抗究竟是多少无关。
来自互联网
2. The decreased effective outputimpedance causes the amp to react less to the speakers.
减少的有效输出阻抗的放大器的原因作出反应较少的发言。
来自互联网
3. A method to reduce the static error and outputimpedance by biasing the TL431 is given.
给出了一种通过偏置tl 431来减小静态误差和输出阻抗的方法。
来自互联网
4. Such a theoretical device would have a zero ohm outputimpedance in series with the source.
这种理论的设备将有一个与源系列零欧姆的输出阻抗。
来自互联网
5. Matching the resistors as closely as tolerances permitted produced an outputimpedance of 43 K ohms.
匹配电阻作为紧密合作，作为公差允许的制作，输出阻抗43k欧姆。
来自互联网
6. A real-world voltage source has a very low, but non-zero outputimpedance: often much less than 1 ohm.
一个真正的世界电压源具有非常低的，但不为零输出阻抗：通常远小于1欧姆。
来自互联网
7. The lower you go with the volume, the lower the outputimpedance of you system becomes and the wider the bandwidth.
你越低，销量与越低，你的输出阻抗系统变得和更广泛的带宽。
来自互联网
8. It also has a low impedance, which assures that the typical unbalanced outputimpedance is between 100 and 1000 ohms.
同时它的低阻抗可以确保典型的非平衡输出阻抗保持在100到1,000欧姆之间。
来自互联网
9. After start-up, the low amplifier outputimpedance reduces reference current variations due to the current through R1.
完成启动后，放大器很低的输出阻抗将会降低因流经R1的电流不足以影响稳压管上的电压稳定性。
来自互联网
10. Normally a headphone amplifiers has a very low outputimpedance which gives the amp tight control over the headphone action.
翻一下：一般情况下耳机放大器为了对耳机控制有很低的输出阻抗。
来自互联网
11. Theory analysis proves that the outputimpedance of parallel system is reduced and the precision of output voltage is improved.
理论分析证明并联系统的输出阻抗减小，输出电压精度提高。
来自互联网
12. This transformer can be used to realize the outputimpedance transformation of the ceramic pulse forming line with low characteristic impedance.
此变压器可用于低阻抗陶瓷脉冲形成线输出端的阻抗变换。
来自互联网
13. Output characteristic is one of the most important characteristics of voltage source inverter, which is determined by the equivalent output impedance of the inverter.
14. Even slight mismatching will cause large errors in the transfer function and degrade the outputimpedance causing the circuit to become less of a true current source.
即使是轻微的错配会造成较大的误差在传递函数和降解输出阻抗造成电路成为少一个真正的电流源。
来自互联网
15. Thus it not only solved the problem of constant output current while load impedance is varied, but also solved the matching problem of output impedance and load impedance.
因此，它不仅解决了负载阻抗变化时输出电流的恒定问题，还解决了输出阻抗与负载阻抗的匹配问题。
来自互联网
16. Optimal design for input filter parameters in the system is accomplished to obtain the minimization of peak outputimpedance, and the design process is discussed in detail.
17. On the "simplifying" conditions, the transfer functions, as well as the input and outputimpedance expressions of the feedback amplifiers, are succinct; and, can be conveniently used.
在“简洁”条件下，反馈放大器的传递函数和输入、输出阻抗具有简洁和便于应用的形式。
来自互联网
18. Contour modulation is a technique in which a phase-modulated signal waveform and amplifier outputimpedance work together to maintain higher efficiency over a sizable output power back-off.
19. Results the result of experiments shows that: although the negative capacitance compensation technique can't let the outputimpedance approach to infinite, it can improve it obviously.
结果：由实验结果发现，负电容补偿技术虽然无法使恒流源输出阻抗值趋于无穷，但是可使其阻抗值明显增大。
来自互联网
20. Most line drivers with low differential outputimpedance will also have inherently low common-mode output impedances, so the low impedance arms of the bridge are almost always at the driver.
21. Switching boost converter's load effect has great effect on input phase, stability of small signal, ratio of input and outputimpedance, and the ratio of Boost converter's output efficiency.
22. By using a series and shunt combination of optocouplers the attenuator can be configured to produces a constant input and outputimpedance, regardless of where the voltage control setting is.
通过使用光耦衰减器的串联和分流相结合可以配置成恒定的输入和输出阻抗，而与控制电压无关。
来自互联网
23. They have a simple construction with low power dissipation and low outputimpedance and can be used as interfacing circuits in VLSI designs to reduce the number of external connections on a chip.
24. This paper presents a novel concept for system integration at system level, which is to select outputimpedance of source converter and input impedance of load converter as objects of standardization.
